Sprag Clutch Assembly - Royal Enfield Bullet Classic EFI Service Manual

SPRAG CLUTCH ASSEMBLY

Ensure the distance between sprag clutch
gear end face and engine sprocket end face
should be maintained between 0.2 to 0.5
mm as indicated in the above image.
NOTE : Crank the engine gently for ease of
assembly.
CAUTION
Do not rotate the starter motor while
assembling as it will damage the "O" ring.
Assemble sprag clutch bearing.
FLANGE FACE
NOTE :
Ensure wide flanges face of the sprag
clutch bearing must face outwards.
Assemble Engine primary sprocket and
sprag clutch gear assembly.
0.2 to 0.5 mm
DETAILS B
CAUTION : Lubricate the needle bearing well
Assemble the primary chain auto chain
tensioner body assy. with "O" ring and tighten
with 2 allen screws (Torque1 KG-M).
Assemble chain tensioner pad, washer and
hex nut ( Torque 2.5 KG-M).
before assembling on the sprag
clutch.
05-51