Wheel Removal & Assembly - Royal Enfield Classic 350 2019 Owner's Manual

WHEEL REMOVAL / ASSEMBLY
FRONT WHEEL REMOVAL
Place the motorcycle on its center stand on a firm

and flat surface.
 Provide a suitable support below the front end of
the engine such that the front wheel is about 4
inches (10 cms.) above the ground.
Disconnect speedo cable.

Loosen the pinch bolt on the right side fork end.

 Hold the axle on the right side and loosen the
axle nut on the left side.
Hold front axle by spanner and loosen axle nut

then remove nut along with washer.
Tap and remove the front wheel spindle from the

right side.
Tilt the motorcycle to right side and take out the

wheel along with speedo drive and right side
spacer.
 Take out Speedo drive and bush on the right side.
32