Table of Contents
Advertisement
Assemble "O" ring, cap pivot, copper
washer and tighten bolt (Torque 1 KG-M).
Check Crank shaft big end bearing axial
play is within service limit.
Check Crank shaft run out is within service
limit.
Assemble the crank shaft into the
crankcase RH.
NOTE :
Ensure the bearing inner races (small one
on timing shaft & big one on drive shaft)
are fitted on the crank shaft before
assembling in the crankcase RH.
Assemble the 2 dowel pins on the
crankcase and apply LOCKTITE 5699 RTV
silicon liquid gasket on the RH Crank case
seating surface.
Assemble special thrust washer (lay
shaft) on Crank case LH.
NOTE :
Ensure special thrust washer profile facing
towards Crank shaft bearing side on LH
Crank case.
05-47
Advertisement
Table of Contents
