Royal Enfield Bullet Classic EFI Service Manual page 132

Fix the dowels in the crankcase and
carefully fix the motor with housing starter
drive. Apply LOCKTITE 5699 RTV silicon
liquid gasket on the joint face.
Fix the 4 Allen screws of housing starter
drive and tighten (Torque 0.6 KG-M).
Fix the main cable on the starter motor on
tighten. Insert rubber boot properly.
Fix the E-Start motor with 2 allen bolts
(Torque 1 KG-M) along with earthing cable.
NOTE :
Apply LOCKTITE 577 thread sealant to
mounting bolts to avoid oil seepage
if any.
Fix the E-Start motor cover.
Assemble spacer (distance washer) on
Crankshaft LH.
CAUTION: This
double stepped
face should be
inside.
05-50