Table of Contents
Advertisement
REMOVAL OF OIL FILTER ELEMENT:
The oil filter element is located on the
Crankcase Cover RH
Remove the oil filter cap mounting screws.
Remove the oil filter cap along with gasket
(Bullet Electra EFI (E5/G5) "O" ring (Bullet
Classic EFI (C5)
Remove the washer, spring, spring cap,
"O" ring and filter element.
NOTE :
Replace oil filter element whenever engine
oil is changed.
RE ASSEMBLY
Soak the new oil filter in oil for 15 minutes.
Refil the oil filter and other parts in the reverse
order of disassembly.
Start Engine, warm up for a few minutes,
switch off engine and check the oil level.
Oil level should be just below 'Max' level.
REAR BRAKE SWITCH ADJUSTMENT
Check brake light switch operation.
Loosen bottom nut and tighten top nut till the
brake light comes on when brake pedal is
pressed.
Tighten the bottom nut duly ensuring that the
brake lamp is not glowing continously.
In case brake light is continously glowing
then readjust till correct position in achieved.
NOTE :
Always re-check brake lamp after
adjustment of brake pedal level and
free play.
REAR WHEEL CHAIN
SLACKNESS ADJUSTMENT :
Check slackness, It should be in between
25 to 30 mm
Ensure to hold the eccentric sleeve by
spanner while tightening the lock nut which
prevent the rotation of the sleeve during
tightening the lock nut.
The backlash is first adjusted between
pinion to exhaust gear and then exhaust to
inlet gear to get effective backlash
adjustment.
03-14
Advertisement
Table of Contents
