Insert the jack shaft from the crankcase
LH inside & fix the woodruf key.
Assemble the crankcase LH over RH
Crank case by tapping gently.
Simultaneously holding self motor jack
shaft carefully.
Tighten the crankcase stud nuts and allen
screws as per the following sequence.
Check connecting rod bend as shown in
Fig.
Assemble Front Engine Mounting Brackets
and tighten bolts (Torque 2.5 KG-M).
Assemble Rear Engine Mounting Bracket
and the piece mudgaurd holding bracket
(Torque 2.5 KG-M).
NOTE :
Ensure " R" index mark side is facing
towards RH side (FD Sprocket) of
the engine.
05-48