Place a washer and tighten nut.
After tightening the swing arm hex nyloc
nut. Remove special Tool ST 25110-3.
Fix both side caps swing pivot carefully.
Assemble both side shock absorbers,
washers and dome nuts as shown in Fig.
Assemble the chain guard.
Assemble the rear wheel and adjust drive
chain free play.
CENTER STAND
CENTER ST
CENTER ST
AND
CENTER ST
CENTER ST
AND
DISASSEMBLY
Disconnect the stand return spring two
nos. (1)
Remove the split pins & washers from the
both ends of the centre stand spindle (2).
Drive out the centre stand spindle.
1
ASSEMBLY
Assemble the centre stand in the reverse
order of disassemble as shown in Fig.
AND
AND
2
08-10