Royal Enfield Bullet Classic EFI Service Manual page 96

Remove the 11 allen screws securing
cover RH. Gently tap & pull out the cover
evenly
It may be necessary to tap the cover
slightly to remove since the magnetic
forces in the rotor can be acting on the
stator and making it difficult to remove
CAUTION :
Tap only at the places shown to avoid
damage to the RH cover
NOTE :
Remove the stator coupler from the
wiring harness before removing RH
Cover.
Place a plastic tray below the RH
cover for collecting the oil that will drip
while removing the cover.
Remove RH cover gasket & 2 dowels.
Remove Pulser coil by removing 2 screws
Remove Stator assembly by removing 3
mounting screws.
05-14