Table of Contents
Advertisement
Tighten the front engine mounting stud nuts
to the specified torque.
Tighten the rear engine stud nuts to the
specified torque.
Tighten the centre stand and foot rest nuts
to the specified torque.
Assemble throttle body and connect the
throttle cables.
Fill recommended the engine oil to the
correct level and tighten filler cap with "O"
ring.
Assemble the exhaust pipe and silencer in
the reverse order of disassembly.
Fix the oxygen sensor & connect to wiring
harness.
Fix the clutch cable & the manual Bi Starter
to the handle bar levers.
Connect all the electrical couplers.
Connect the brake light switch to the pedal.
Connect the fuel hose to the pump.
Assemble the battery & connect the
terminals. Check for proper working of all
electrical equipments.
Fix the dual seat.
Start machine and run in idle RPM for few
minutes. Switch off & check oil level add
oil to bring level below "Max" level.
Adjust rear brake and chain terminals. Align
the rear wheel.
05-70
Advertisement
Table of Contents
