Table of Contents
Advertisement
Screw in or out the cable adjuster for
setting the required play at lever end (2 to
3 mm).
After adjustment refix cable boot.
PRIMARY CHAIN TENSION ADJUSTMENT
This vehicle is fitted with Auto chain
tensioner. Hence there is no need for
periodic manual adjustment.
THROTTLE CABLE PLAY
ADJUSTMENT
Throttle rotor free play 2-3 mm.
There are two adjuster provided - one at the top
near the throttle grip and the other on the throttle
body. Minor adjustments can be carried out at
the top.
(A ) ADJUSTMENT AT HANDLE BAR END
Slide the rubber boot, use 10 mm spanner
to adjust cable outer and lock the nut. Move
the rubber boot over the lock nuts.
(B ) ADJUSTMENT AT THROTTLE BODY END
Loosen the lock nuts on both the cables.
Adjust both cables unitform and tighten the
lock nuts.
THROTTLE CABLE ASSY REPLACEMENT
While replacing throttle cable following
procedure is recommended
- (A) Connect throttle cable to Rotor /
throttle grip assembly
- (B) Connect cable to throttle body and
ensure the recommended free play.
- (C) Route and strap the cable properly.
BATTERY ELECTROLYTE LEVEL :
Electrolyte level can be seen through the
casing
Level to be between max and min marks
Incase of maintenanace free
NOTE :
battery following procedure not applicable.
03-19
Advertisement
Table of Contents
