Swing Arm - Royal Enfield Bullet Classic EFI Service Manual

RECHARGING OF SHOCK
ABSORBERS
Remove the small screw with "O" Ring.
Inject the special purpose needle into the
hole provided in the screw (Puncturing
the rubber) and start pumping the air into
the chamber till the pressure reached to
100 PSI (7 BAR). Tolerance for filling
pressure can be 6.7 BAR to 7 BAR.
Fit the small screw with "O" Ring.
NOTE:
The shock absorber needs recharging
when the system pressure is less than 5
BAR.

SWING ARM

SWING ARM SWING ARM
SWING ARM SWING ARM
REMOVAL
Remove the chain link and take out the
chain.
Disconnect the brake rod nut.
Remove the rear wheel sprocket
assembly (1).
Remove the shock absorbers (2).
1 1 1 1 1
Remove the chain guard.
Remove the swing arm cap swing pivot.
Remove the swing arm hex nyloc nut &
washer.
Tap and pull out the swing arm flange hex
bolt.
2 2 2 2 2
08-8