Table of Contents
Advertisement
Assemble 6305 - C3 bearing after 1st
circlip. Insert 2nd circlip then bearing
spacer in Crank case LH as shown in Fig.
Assemble NU 305 big roller bearing after
bearing spacer in LH Crank case for
crankshaft.
CRANKCASE RH
Assemble Needle bearing for lay shaft.
Assemble sleeve gear ball bearing (6007
R1/C3) and circlip.
NOTE :
Ensure the rubber sealed face is facing
the
FD
sprocket
assembling the 6007 bearing.
Insert circlip and then assemble crankshaft
RH side needle roller bearing into Crank
case.
side,
while
05-38
Advertisement
Table of Contents
