Reverse Bleeding Method - Royal Enfield Bullet Classic EFI Service Manual

Loosen the bleeder screw by ½ turn to
allow air bubbles in the brake system to
escape out.
When the bleeder screw is loosened and
the air escapes out along with the brake
fluid through the bleeder nipple, the brake
lever will further depress. Allow the lever
to depress fully and hold. DO NOT
RELEASE THE LEVER.
Tighten the bleeder screw firmly and then
only release the brake lever.
NOTE:
Check the fluid level in the master
cylinder and top up if necessary till the
"MAX" mark.
Repeat the process detailed above, till the
brake lever movement is minimal and locks
in applied position. Also check and ensure
there are no more air bubbles being carried
out by the fluid while bleeding the system.
Ensure the bleeder screw is tightened fully
and fix the dust cap.
Check the fluid level and top up to "MAX"
level and refit the diaphragm and the top
cover and tighten with the screws.
Check for any leaks at the banjo or the
bleeding screw area and ensure all
mounting bolts are tightened to the correct
torque.
BLEEDING PROCEEDURE BLEEDING PROCEEDURE BLEEDING PROCEEDURE BLEEDING PROCEEDURE BLEEDING PROCEEDURE

REVERSE BLEEDING METHOD:

Ensure the bleeding screw and the brake
hose banjo is fully tight.
Fill the master cylinder with brake fluid from
a sealed container, till the "Max" level.
Depress the brake lever completely and
release fully so as to allow the fluid to travel
into the brake hose and the wheel caliper.
07-7