IBM RS/6000 Enterprise Server M80 Service Manual page 358

Table 9. Common Firmware Error Codes (continued)
Error Code Description
B1FD 0016 Diskette read error
B1FD 001A Service processor firmware update fault
B1FD 001E System firmware update Fault
B1FD 001F Bad diskette
B1xx 0013 A firmware update has failed because the
update image is invalid. The update was
aborted before any changes were made to
the currently installed firmware.
B1xx 4600 Service processor error
B1xx 4601 CPU subsystem problem
B1xx 4602 RIO bus fault
B1xx 4603 CSP firmware corrupted
B1xx 4606 Firmware failure
B1xx 4608 CSP early termination
B1xx 460A TOD clock has been reset
B1xx 460B TOD battery failure
B1xx 4611 Service processor fault
340
Service Guide
Action/
Possible Failing FRU
1. The firmware diskette may be faulty. Try
another diskette.
2. Replace the diskette drive.
3. Replace the primary I/O backplane.
Reset the service processor with the pinhole
reset or by disconnecting then reconnecting
power.
Wrong system firmware update diskette.
Insert correct diskette.
Replace diskette
Install a valid firmware update image for the
specific system type and model.
Primary I/O drawer backplane
Location: U0.1-P1
No isolation possible, contact next level of
support.
1. Check/reseat RIO cables
2. RIO bus adapter
Location: U0.1-P1.1
3. CEC RIO adapter
Location: U1.1-P1.1
1. Reload system firmware
2. Primary I/O backplane
Location: U0.1-P1
1. Check for system firmware updates
Location: U0.1-P1/Y1
2. Primary I/O drawer operator panel
Location: U0.1-L1
3. Primary I/O drawer backplane
Location: U0.1-P1
1. Reset the system by disconnecting and
reconnecting system power
2. Reload system firmware
3. Primary I/O backplane
Location: U0.1-P1
1. Set TOD Clock
2. Primary I/O Drawer Backplane
Location: U0.1-P1
Replace TOD battery
Location: U0.1-P1-V3
1. Primary I/O drawer backplane
Location: U0.1-P1
2. Processor card
Locations: U1.1-P1-C1
U1.1-P1-C2