IBM RS/6000 Enterprise Server M80 Service Manual page 159

Table 1. Service Processor Checkpoints (continued)
Checkpoint Description
9184 Firmware image being loaded
into service processor's control
storage during firmware update
91FF Control being handed to system
processor from service
processor
9380 Built-in-self-test (BIST)
94B0 Wire test faulty driver status
refcode
94B1 Wire test shorted net status
refcode
94B2 Wire test L2 cache status
refcode
94BB Wire test status SRC refcode
9501 Main storage initialization
9502 Main storage L3 cache march
test
9503 Main storage L3 connections
test
9504 Main storage L3 cache march
test
9505 MS extra testing (RIO, etc.)
9506 MS cleanup
99FD Service processor receiving
firmware update module
99FF Service processor writing
firmware update module
A800 Start service processor dump
process
A801 Start dump to debug port
A802 Start dump to debug port
A803 NVRAM not usable
A804 NVRAM dump done
A805 Start dump to flash
A806 Flash dump area done
Action/
Possible Failing FRU
1. Remove, then reapply
power to the system. If
the service processor
enters recovery mode,
(indicated by A1FD 0000
in the display), attempt to
update the firmware
again in recovery mode.
If the service processor
comes up to the OK
prompt, try again to
update the firmware using
the service processor
menus.
2. Call service support
See note 2 on page 142
See note 2 on page 142
See note 2 on page 142
See note 2 on page 142
See note 2 on page 142
See note 2 on page 142
See note 2 on page 142
See note 2 on page 142
See note 2 on page 142
See note 2 on page 142
See note 2 on page 142
See note 2 on page 142
See note 1 on page 142
See note 1 on page 142
See note 1 on page 142
See note 1 on page 142
See note 1 on page 142
See note 1 on page 142
See note 1 on page 142
See note 1 on page 142
See note 1 on page 142
141
Chapter 4. Checkpoints