Table of Contents
Advertisement
To charge a battery, the Graupner Ultramat 14 plus charger must be powered on first.
1
Connect the Graupner Ultramat 14 plus charger to a:
●
12 V car battery
●
100-240 VAC power supply
R
:
ESULT
Once powered on, the Graupner Ultramat 14 plus charger displays the following messages:
1
A welcome message.
2
An indication that safety timer is on. The safety timer is a built-in safety that stops the
charging process after a defined time span. The programmed setting is 110 minutes.
This is enough to fully charge an empty battery for the X100.
3
An indication that the buzzer is on. The buzzer is an audible signal that gives feedback
when charging is complete or when an error occurred.
4
The programmed settings for charging the battery of the X100.
12.6 Battery charging parameters
12.6.1
Default parameters
By default, the display of the Graupner Ultramat 14 plus charger shows the following parame-
ters for the X100 battery:
LiPo manual
●
C:5,0A 8000mAh
●
D
: The maximum charging current is limited to 5 A. This value must be lower than the
ANGER
maximum permissible current (8 A) for the X100 battery.
D
: Wrong battery charging parameters can destroy your battery and cause it to catch
ANGER
fire or explode.
12.6.2
Change settings
If the Graupner Ultramat 14 plus charger does not display the default parameters, you have to
change the settings. Read the Graupner Ultramat 14 plus charger Operating Manual to do so.
You can find this manual on www.graupner.de.
12.7 Charge a battery
P
REREQUISITES
●
X100 battery
●
Powered on Graupner Ultramat 14 plus charger
2.0
Battery
Battery charging parameters
— 94 —
12 October 2012
Advertisement
Table of Contents
