Put The X100 In Download Mode; Put The X100 In Off Mode; Make The X100 Exit Error Mode - Gatewing X100UAS System Manual

8.10 Put the X100 in DOWNLOAD mode

P
REREQUISITES
● X100 with eBox in STANDBY mode and GPS antenna removed
To download the data from the camera, the X100 must be put in DOWNLOAD mode.
1. Hold down the CONTROL button until the ON LED has flashed three times.
R :
The X100 is in DOWNLOAD mode. On the eBox, the ON LED is blinking.
ESULT

8.11 Put the X100 in OFF mode

P
REREQUISITES
● X100 with eBox in STANDBY or DOWNLOAD mode
The STANDBY and DOWNLOAD mode are the only two valid modes to put the aircraft in OFF
mode. Doing this starting from the ON or ARMED mode will result in an error when re-initial-
izing the X100.
1. Disconnect the eBox from the battery.
R :
The X100 is in OFF mode. On the eBox, no LEDs are lit.
ESULT

8.12 Make the X100 exit ERROR mode

P
REREQUISITES
● X100 with eBox in ERROR mode
When the X100 is in ERROR mode, this is indicated by one of the following:
● ON and READY LED blinking
● Audible error signal
To make the aircraft exit this mode and clear all settings, the X100 must be reset and put in
OFF mode.
1 Hold down the CONTROL button until the ON LED has flashed three times.
2 Disconnect the main power connector of the battery from the X100.
R :
The X100 is in OFF mode. On the eBox, no LEDs are lit.
ESULT
2.0
eBox
Put the X100 in DOWNLOAD mode
— 65 — 12 October 2012