Check The Airspeed Sensor Response - Gatewing X100UAS System Manual

3 Click OK to confirm.
4 Perform a POWER CYCLE on the X100.
R :
The airspeed sensor has been reset.
ESULT
A C
FTER OMPLETING

17.7 Check the airspeed sensor response

P
REREQUISITES
● GCS with flight plan exported to Horizon and uploaded to the X100
● Wireless link between GCS and X100 (LINK field green)
● X100 fully initialized
After a reset of the airspeed sensor, it is important to check if this sensor is working correctly.
This must be done before each flight.
1 Remove the pitot cover from the pitot tube.
2 Open Horizon.
3 Press and hold your finger on the pitot tube for a few seconds while verifying if the Hori-
zon airspeed indicator shows a swift increase in airspeed.
W
ARNING
the X100 will assume it is flying and will try to start the motor.
R :
ESULT
● Swift increase
If the Horizon airspeed indicator shows a swift increase in airspeed, the airspeed
sensor is working correctly.
● Slow or no increase
Do not use the X100 for flight when there is no increase or only a slow increase in
airspeed. Check the following items:
○ The connection between silicon tube and pitot tube.
○ The connection between silicon tube and eBox.
○ The pitot tube must be clear of dirt.
○ If the problem remains, contact your local dealer.
2.0
Horizon
Check the airspeed sensor response
T T :
Check the airspeed sensor response.
HIS ASK
: Do not hold your finger on the pitot tube for more than five seconds, otherwise
— 126 — 12 October 2012