Table of Contents
Advertisement
C
: Always check a flight plan with a simulation before using it for a flight.
AUTION
1
Select UAV-01 from the Autopilot Control list.
2
Click Simulate.
S
R
TEP
3
Click Arm to indicate a pending launch.
4
Click Catapult to simulate a launch of the X100.
5
Once the first flight line is completed and checked, click LAND.
S
R
TEP
accompanied by an audible signal.
6
Click Acknowledge Circuit to acknowledge that the X100 is landing according to the
defined landing circuit.
7
Once the X100 has landed, click Terminate to end the simulation.
R
:
ESULT
When the project area is displayed correctly and the simulation of the flight was according to
your expectations, you can use the flight plan and upload it to the X100.
If not, make the necessary changes in Quickfield and create a new flight plan. Possible
reasons to make changes are:
●
The X100 flies in prohibited areas during take-off, turns, landing, ...
●
The landing heading does not provide enough obstacle clearance.
19.4.4
Screw the data link antenna on the eBox
P
REREQUISITES
●
Data link antenna
●
eBox
The data link antenna must be screwed onto the eBox to ensure a wireless (RF) link between
the GCS and the X100.
1
Click and screw the data link antenna onto the data link antenna connector of the eBox.
2.0
Prepare for flight
Flight plan
:
The flight plan appears over the background map.
ESULT
:
A window appears showing the landing circuit the X100 will follow. This is
ESULT
— 156 —
12 October 2012
Advertisement
Table of Contents
