Table of Contents
Advertisement
8.8
Make the X100 return to STANDBY mode
P
REREQUISITES
●
X100 prepared for flight with eBox in ON, ARMED or DOWNLOAD mode
Gatewing advises to make the X100 return to STANDBY mode when:
●
The flight is interrupted
●
The flight is delayed
●
The data is downloaded
1.
Hold down the CONTROL button until the ON LED has flashed three times.
R
:
The X100 is in STANDBY mode. On the eBox, the READY LED is blinking.
ESULT
8.9
Perform a POWER CYCLE on the X100
P
REREQUISITES
●
X100 prepared for flight with eBox in ON mode
●
Fixed GPS position
●
Radio link between GCS and X100
Sometimes it is necessary to reinitialize the X100, e.g. when the airspeed sensor has been
reset. During a POWER CYCLE, the X100 performs the following actions:
●
Acquire a new GPS lock.
●
Check the elevons and put them in zero position.
●
Initialize the internal sensors (airspeed sensor, accelerometers, altitude pressure sensor,
gyros, ...) of the eBox.
●
Download the flight plan to your GCS (Horizon).
1
Hold down the CONTROL button until the ON LED has flashed once. The X100 starts a
full reinitialization.
●
The initialization of the X100 takes about 25 seconds. In its final steps the aircraft will
move its elevons up and down once.
●
Make sure the X100 does not move during initialization.
R
:
ESULT
The X100 has fully reinitialized and is back in ON mode. On the eBox, the READY LED is lit
and the ON LED is blinking.
2.0
eBox
Make the X100 return to STANDBY mode
— 64 —
12 October 2012
Advertisement
Table of Contents
