Reset The Airspeed Sensor - Gatewing X100UAS System Manual

3 Click Transmit to start the upload.
S R
TEP
memory of the X100 autopilot. When the upload is finished, the two bottom bars in the
dialog are green and the message Transmission complete is shown in the lower bottom
bar.
If you receive an error message when clicking Transmit, check the error message:
Error message
Autopilot is not currently set
for in flight re-programming
(no fixed command)
Unable to transmit FLY file
because the autopilot is
initialized and ready
4 Close the dialog.
5 Perform a POWER CYCLE on the eBox.
R :
The flight plan is present in the non-volatile memory of the X100 autopilot.
ESULT

17.6 Reset the airspeed sensor

P
REREQUISITES
● GCS with flight plan exported to Horizon and uploaded to the X100
● Wireless link between GCS and X100 (LINK field green)
● X100 with pitot tube covered by pitot cover
Due to various factors (transportation, temperature change, set up of the X100, ...), the
airspeed sensor may produce results with an offset error. Therefore, a reset of this sensor is
mandatory before each flight.
1 Open Horizon.
2 Select AutoPilot > Reset Airspeed Sensor in the menu bar.
S R
TEP
asking to perform a POWER CYCLE on the X100.
2.0
Reset the airspeed sensor
:
The flight plan is now uploaded, verified and saved in the non-volatile
ESULT
There is already a wireless
link established.
The GPS antenna is
mounted.
:
A dialog appears indicating the airspeed sensor has been reset and
ESULT
— 125 —
Horizon
Error Action to perform
Restart Horizon and repeat
this procedure.
Remove GPS antenna from
the X100 and repeat this
procedure.
12 October 2012