Table of Contents
Advertisement
4
Stop tightening the launch cable when the outer end of the cable (where it is attached to
the yellow cord) is situated between the seventh and the second to third hole from the top
in the launch slide.
N
: When using a torque wrench, tighten the launcher up to 16 Nm.
OTE
W
ARNING
the last hole when tightening the cable, Gatewing recommends to replace the launch
cable to prevent unsuccessful launches.
5
Take the X100 by its launcher slats and place it correctly on the launch dock. The lips of
the launch dock must be inside the launcher slats.
W
ARNING
are no obstructions between the X100 and the launch dock. A bad placement of the
X100 can result in an unsuccessful launch.
2.0
Prepare for flight
Launch
: The launch cable stretches out with every launch. When you can easily reach
: Make sure both launcher slats rest completely on the launch dock and there
— 172 —
12 October 2012
Advertisement
Table of Contents
