Table of Contents
Advertisement
3
Tighten the launch cable by turning the crank gently clockwise.
N
: Make sure the launch cable is not twisted when tightening.
OTE
4
Stop tightening the launch cable when the outer end of the cable (where it is attached to
the yellow cord) is situated between the seventh and the second to third hole from the top
in the launch slide.
N
: When using a torque wrench, tighten the launcher up to 16 Nm.
OTE
W
ARNING
the last hole when tightening the cable, Gatewing recommends to replace the launch
cable to prevent unsuccessful launches.
2.0
Launcher
Mount the X100 on the launcher
: The launch cable stretches out with every launch. When you can easily reach
— 86 —
12 October 2012
Advertisement
Table of Contents
