Mount The Camera In The Aircraft; Put An F22 Transmitter In The X100 - Gatewing X100UAS System Manual

19.5.4

Mount the camera in the aircraft

P
REREQUISITES
● X100 body
● Assembled Ricoh camera
The camera must be mounted correctly to ensure correct balance of the X100.
1 Remove the top cover from the payload bay of the X100 body.
2 Connect the USB camera connector to the Ricoh camera.
3 Place the Ricoh camera into the camera compartment of the payload bay.
N : Make sure the lens and UV filter are clean.
OTE
4 Place the foam block around the Ricoh camera to secure its position.
R :
ESULT
The camera is mounted in the X100.
N : Make sure the USB camera connector is still connected after placing it in the X100
OTE
body.
19.5.5

Put an F22 transmitter in the X100

P
REREQUISITES
● F22 transmitter which is stored in memory of the R1 receiver
● X100
Sometimes it is necessary to track down the X100. To make the X100 traceable, an F22 trans-
mitter must be inserted.
1 Power on the F22 transmitter.
2 Place the F22 transmitter in the payload bay of the X100.
2.0
Prepare for flight
Preparation of the X100 for launch
— 163 — 12 October 2012