Table of Contents
Advertisement
7.3
Assemble the camera
P
REREQUISITES
●
Ricoh camera
●
Clean UV filter (diameter 43 mm)
●
GH-2 adaptor for general purposes
●
Empty SD card (8 GB)
●
Charged Li-ion rechargeable battery (3.7 V-1250 mAh)
You have to assemble the camera before you can use it for a flight.
1
Make sure the camera is switched off.
2
Rotate the ring cap counterclockwise and remove it from the body.
3
Rotate the adaptor clockwise onto the Ricoh camera until it clicks.
4
Screw the clean UV filter clockwise onto the adaptor.
5
Slide the empty SD card into the SD card slot of the Ricoh camera.
6
Insert the charged battery in the battery compartment of the Ricoh camera.
7.4
Set up the camera
When you receive the Ricoh camera, it is already set up by Gatewing. If you have reset the
camera, please set the following parameters:
●
Set key addressing off
●
Set up auto power off
7.4.1
Set key addressing off
1
Press the MENU/OK button to enter the menu.
2
Select Key Custom Options by pressing left and down.
3
Press down three times to select My Settings for Fn Settings.
4
Press right once to see the possible values.
5
Select Off.
6
Press the MENU/OK button to confirm.
7.4.2
Set up auto power off
1
Press the MENU/OK button to enter the menu.
2
Select Setup Menu by pressing left and down.
3
Press down five times to select Auto Power Off.
2.0
Camera
Assemble the camera
— 57 —
12 October 2012
Advertisement
Table of Contents
