Table of Contents
Advertisement
4
Command Line Interface
ip igmp snooping router-port-expire-time
This command configures the query timeout. Use the no form to restore the default.
Syntax
ip igmp snooping router-port-expire-time seconds
no ip igmp snooping router-port-expire-time
seconds - The time the switch waits after the previous querier stops before
it considers the router port (i.e., the interface which had been receiving
query packets) to have expired.
(Range: 300-500)
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The switch must use IGMPv2 for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Related Commands
ip igmp snooping version (4-229)
Static Multicast Routing Commands
Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter
4-234
Table 4-76 Static Multicast Routing Commands
Function
Adds a multicast router port
Shows multicast router ports
Mode
Page
GC
4-235
PE
4-235
Advertisement
Table of Contents
