Line Commands - Edge-Core ES3628C Management Manual

Command Group
Multicast Routing
Router Redundancy
The access mode shown in the following tables is indicated by these abbreviations:
NE (Normal Exec)
PE (Privileged Exec)
GC (Global Configuration)
LC (Line Configuration)
IC (Interface Configuration)
VC (VLAN Database Configuration)

Line Commands

You can access the onboard configuration program by attaching a VT100
compatible device to the server's serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Command Function
line Identifies a specific line for configuration and starts the line
configuration mode
login Enables password checking at login
password Specifies a password on a line
timeout login Sets the interval that the system waits for a login attempt
response
exec-timeout Sets the interval that the command interpreter waits until user
input is detected
password-thresh Sets the password intrusion threshold, which limits the number of
failed logon attempts
Sets the amount of time the management console is inaccessible
*
silent-time
after the number of unsuccessful logon attempts exceeds the
threshold set by the password-thresh command
Sets the number of data bits per character that are interpreted and
*
databits
generated by hardware
Defines the generation of a parity bit
*
parity
Sets the terminal baud rate
*
speed
Sets the number of the stop bits transmitted per byte
*
stopbits
disconnect Terminates a line connection
show line Displays a terminal line's parameters
* These commands only apply to the serial port.
Table 4-4 Command Group Index (Continued)
Description
Configures multicast routing protocols DVMRP and PIM-DM
Configures router redundancy to create primary and backup routers
MST (Multiple Spanning Tree)
ACL (Access Control List Configuration)
DC (DHCP Server Configuration)
RC (Router Configuration)
CM (Class Map Configuration)
PM (Policy Map Configuration)
Table 4-5 Line Commands
4
Line Commands
Page
4-297
4-316
Mode Page
GC 4-12
LC 4-12
LC 4-13
LC 4-14
LC 4-15
LC 4-15
LC 4-16
LC 4-17
LC 4-17
LC 4-18
LC 4-18
PE 4-19
NE, PE 4-19
4-11