Show Tacacs-Server; Port Security Commands - Edge-Core ES3628C Management Manual

show tacacs-server

This command displays the current settings for the TACACS+ server.
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show tacacs-server
Remote TACACS server configuration:
Server IP address:
Communication key with TACACS server: *****
Server port number:
Console#

Port Security Commands

These commands can be used to enable port security on a port. When using port
security, the switch stops learning new MAC addresses on the specified port when it
has reached a configured maximum number. Only incoming traffic with source
addresses already stored in the dynamic or static address table for this port will be
authorized to access the network. The port will drop any incoming frames with a
source MAC address that is unknown or has been previously learned from another
port. If a device with an unauthorized MAC address attempts to use the switch port,
the intrusion will be detected and the switch can automatically take action by
disabling the port and sending a trap message.
Command
port security
mac-address-table static
show mac-address-table
Table 4-31 Port Security Commands
Function
Configures a secure port
Maps a static address to a port in a VLAN
Displays entries in the bridge-forwarding database
Authentication Commands
10.11.12.13
49
4
Mode Page
IC 4-78
GC 4-167
PE 4-168
4-77