Clear Counters - Edge-Core ES3628C Management Manual

Command Usage
• When broadcast traffic exceeds the specified threshold, packets above that
threshold are dropped.
• Broadcast control does not effect IP multicast traffic.
• The resolution is 1 packet per second (pps); i.e., any setting between
500-262143 is acceptable.
Example
The following shows how to configure broadcast storm control at 600 packets per
second:
Console(config)#interface ethernet 1/5
Console(config-if)#switchport broadcast packet-rate 600
Console(config-if)#

clear counters

This command clears statistics on an interface.
Syntax
clear counters interface
interface
• ethernet unit/port
- unit - Stack unit
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-12)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Statistics are only initialized for a power reset. This command sets the base
value for displayed statistics to zero for the current management session.
However, if you log out and back into the management interface, the statistics
displayed will show the absolute value accumulated since the last power reset.
Example
The following example clears statistics on port 5.
Console#clear counters ethernet 1/5
Console#
42. Stacking is not supported in the current firmware.
42
. (Range: 1-1)
Interface Commands
4
4-149