Table of Contents
Advertisement
3
Configuring the Switch
• Flow control – Shows if flow control is enabled or disabled.
• LACP – Shows if LACP is enabled or disabled.
• Port security – Shows if port security is enabled or disabled.
• Max MAC count – Shows the maximum number of MAC address that can be
learned by a port. (0 - 1024 addresses)
• Port security action – Shows the response to take when a security violation is
detected. (shutdown, trap, trap-and-shutdown)
Current status:
• Link status – Indicates if the link is up or down.
• Port operation status – Provides detailed information on port state.
(Displayed only when the link is up.).
• Operation speed-duplex – Shows the current speed and duplex mode.
• Flow control type – Indicates the type of flow control currently in use.
(IEEE 802.3x, Back-Pressure or none)
CLI – This example shows the connection status for Port 5.
Console#show interfaces status ethernet 1/5
Information of Eth 1/13
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin:
Speed-duplex:
Capabilities:
Broadcast storm:
Broadcast storm limit:
Flow control:
LACP:
Port security:
Max MAC count:
Port security action:
Media type:
Current status:
Link status:
Operation speed-duplex: 1000full
Flow control type:
Console#
3-90
100TX
00-30-F1-D4-73-A5
Up
Auto
10half, 10full, 100half, 100full, 1000full
Enabled
500 packets/second
Disabled
Disabled
Disabled
0
None
None
Down
None
4-150
Advertisement
Table of Contents
