Table of Contents
Advertisement
- Network or host unreachable - The gateway found no corresponding entry
in the route table.
• Press <Esc> to stop pinging.
Example
Console#ping 10.1.0.9
Type ESC to abort.
PING to 10.1.0.9, by 5 32-byte payload ICMP packets, timeout is 5 seconds
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 0 ms
Ping statistics for 10.1.0.9:
5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)
Approximate round trip times:
Minimum = 0 ms, Maximum = 10 ms, Average = 8 ms
Console#
Related Commands
interface (4-143)
Address Resolution Protocol (ARP)
Command
arp
arp-timeout
clear arp-cache
show arp
ip proxy-arp
arp
This command adds a static entry in the Address Resolution Protocol (ARP) cache.
Use the no form to remove an entry from the cache.
Syntax
arp ip-address hardware-address
no arp ip-address
• ip-address - IP address to map to a specified hardware address.
• hardware-address - Hardware address to map to a specified IP address.
(The format for this address is xx-xx-xx-xx-xx-xx.)
Default Setting
No default entries
Command Mode
Global Configuration
Table 4-81 Address Resolution Protocol Commands
Function
Adds a static entry in the ARP cache
Sets the time a dynamic entry remains in the ARP cache
Deletes all dynamic entries from the ARP cache
Displays entries in the ARP cache
Enables proxy ARP service
IP Interface Commands
Mode
GC
GC
PE
NE, PE 4-249
VC
4
Page
4-247
4-248
4-249
4-250
4-247
Advertisement
Table of Contents
