Table of Contents
Advertisement
3
Configuring the Switch
To delete a file select System, File Management, Delete. Select the file name from
the given list by checking the tick box and click Apply. Note that the file currently
designated as the startup code cannot be deleted.
CLI – To download new firmware form a TFTP server, enter the IP address of the
TFTP server, select "config" as the file type, then enter the source and destination
file names. When the file has finished downloading, set the new file to start up the
system, and then restart the switch.
To start the new firmware, enter the "reload" command or reboot the system.
Console#copy tftp file
TFTP server ip address: 10.1.0.19
Choose file type:
1. config:
2. opcode: <1-2>: 2
Source file name: V3.1.0.18.bix
Destination file name: V31018
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#config
Console(config)#boot system opcode:V31018
Console(config)#exit
Console#reload
3-22
Figure 3-12 Deleting Files
4-64
4-68
4-23
Advertisement
Table of Contents
