Table of Contents
Advertisement
nbr-timeout
This command sets the interval to wait for messages from a DVMRP neighbor
before declaring it dead. Use the no form to restore the default value.
Syntax
nbr-timeout seconds
no nbr-timeout
seconds - Interval before declaring a neighbor dead. (Range: 1-65535)
Default Setting
35 seconds
Command Mode
Router Configuration
Command Usage
This command is used for timing out routes, and for setting the children and
leaf flags.
Example
Console(config-router)#nbr-timeout 40
Console(config-router)#
report-interval
This command specifies how often to propagate the complete set of routing tables to
other neighbor DVMRP routers. Use the no form to restore the default value.
Syntax
report-interval seconds
no report-interval
seconds - Interval between sending the complete set of routing tables.
(Range: 1-65535)
Default Setting
60 seconds
Command Mode
Router Configuration
Example
Console(config-router)#report-interval 90
Console(config-router)#
Multicast Routing Commands
4
4-303
Advertisement
Table of Contents
