Show Spanning-Tree Mst Configuration; Vlan Commands; Editing Vlan Groups; Commands For Editing Vlan Groups - Edge-Core ES3628C Management Manual

4
Command Line Interface

show spanning-tree mst configuration

This command shows the configuration of the multiple spanning tree.
Command Mode
Privileged Exec
Example
Console#show spanning-tree mst configuration
Mstp Configuration Information
--------------------------------------------------------------
Configuration name: R&D
Revision level:0
Instance Vlans
--------------------------------------------------------------
1 2
Console#

VLAN Commands

A VLAN is a group of ports that can be located anywhere in the network, but
communicate as though they belong to the same physical segment. This section
describes commands used to create VLAN groups, add port members, specify how
VLAN tagging is used, and enable automatic VLAN registration for the selected
interface.
Command Groups

Editing VLAN Groups

Configuring VLAN
Interfaces
Displaying VLAN
Information
Configuring Private VLANs
Configuring Protocol VLANs Configures protocol-based VLANs based on frame type and protocol
Editing VLAN Groups
Command
vlan database
vlan
4-188
Table 4-59 VLAN Commands
Function
Sets up VLAN groups, including name, VID and state
Configures VLAN interface parameters, including ingress and egress
tagging mode, ingress filtering, PVID, and GVRP
Displays VLAN groups, status, port members, and MAC addresses
Configures private VLANs, including uplink and downlink ports
Table 4-60 Commands for Editing VLAN Groups
Function
Enters VLAN database mode to add, change, and delete
VLANs
Configures a VLAN, including VID, name and state
Page
4-188
4-190
4-195
4-197
4-198
Mode Page
GC 4-189
VC 4-189