Table of Contents
Advertisement
4
Command Line Interface
Notes: 1.
You can only configure one rule per Class Map. However, you can include
multiple classes in a Policy Map.
2.
You must create a Class Map before creating a Policy Map.
class-map
This command creates a class map used for matching packets to the specified
class, and enters Class Map configuration mode. Use the no form to delete a class
map and return to Global configuration mode.
Syntax
[no] class-map class-map-name [match-any]
• match-any - Match any condition within a class map.
• class-map-name - Name of the class map. (Range: 1-32 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• First enter this command to designate a class map and enter the Class Map
configuration mode. Then use the match command (page 4-221) to specify
the criteria for ingress traffic that will be classified under this class map.
• Only one match command is permitted per class map, so the match-any field
refers to the criteria specified by the lone match command for a class map.
• The class map uses the Access Control List filtering engine, so you must also
set an ACL mask to enable filtering for the criteria specified in the match
command. See "mask (IP ACL)" on page 4-93 or "mask (MAC ACL)" on
page 4-102 for information on configuring an appropriate ACL mask.
• The class map is used with a policy map (page 4-222) to create a service
policy (page 4-225) for a specific interface that defines packet classification,
service tagging, and bandwidth policing.
Example
This example creates a class map call "rd_class," and sets it to match packets
marked for DSCP service value 3:
Console(config)#class-map rd_class match-any
Console(config-cmap)#match ip dscp 3
Console(config-cmap)#exit
Console(config)#access-list ip mask-precedence in
Console(config-ip-mask-acl)#mask any any dscp
Console(config-ip-mask-acl)#
Related Commands
show class map (4-226)
4-220
Advertisement
Table of Contents
