Igmp Commands (Layer 3); Ip Igmp - Edge-Core ES3628C Management Manual

4
Command Line Interface
Command Usage
Multicast router port types displayed include Static or Dynamic.
Example
The following shows that port 11 in VLAN 1 is attached to a multicast router:
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Ports Type
---- ------------------- -------
1
2
Console#

IGMP Commands (Layer 3)

Command

ip igmp

ip igmp robustval
ip igmp query-interval
ip igmp max-resp-interval
ip igmp
last-memb-query-interval
ip igmp version
show ip igmp interface
clear ip igmp group
show ip igmp groups
ip igmp
This command enables IGMP on a VLAN interface. Use the no form of this
command to disable IGMP on the specified interface.
Syntax
[no] ip igmp
Default Setting
Disabled
Command Mode
Interface Configuration (VLAN)
Command Usage
IGMP query can be enabled globally at Layer 2 via the ip igmp snooping
command, or enabled for specific VLAN interfaces at Layer 3 via the ip igmp
command. (Layer 2 query is disabled if Layer 3 query is enabled.)
4-236
Eth 1/11 Static
Eth 1/12 Dynamic
Table 4-77 IGMP Commands (Layer 3)
Function
Enables IGMP for the specified interface
Configures the expected packet loss
Configures frequency for sending host query messages
Configures the maximum host response time
Configures frequency for sending group-specific host query
messages
Configures IGMP version used on this interface
Displays the IGMP configuration for specified interfaces
Deletes entries from the IGMP cache
Displays detailed information for IGMP groups
Mode Page
IC 4-236
IC 4-237
IC 4-238
IC 4-238
IC 4-239
IC 4-240
NE, PE 4-240
PE 4-241
NE, PE 4-241