Table of Contents
Advertisement
4
Command Line Interface
• You can delete an address range just by specifying the start address, or by
specifying both the start address and end address.
Example
This example restricts management access to the indicated addresses.
Console(config)#management all-client 192.168.1.19
Console(config)#management all-client 192.168.1.25 192.168.1.30
Console#
show management
This command displays the client IP addresses that are allowed management
access to the switch through various protocols.
Syntax
show management {all-client | http-client | snmp-client | telnet-client}
• all-client - Adds IP address(es) to the SNMP, web and Telnet groups.
• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
Command Mode
Privileged Exec
Example
Console#show management all-client
Management Ip Filter
HTTP-Client:
Start IP address
-----------------------------------------------
1. 192.168.1.19
2. 192.168.1.25
SNMP-Client:
Start IP address
-----------------------------------------------
1. 192.168.1.19
2. 192.168.1.25
TELNET-Client:
Start IP address
-----------------------------------------------
1. 192.168.1.19
2. 192.168.1.25
Console#
4-30
End IP address
192.168.1.19
192.168.1.30
End IP address
192.168.1.19
192.168.1.30
End IP address
192.168.1.19
192.168.1.30
Advertisement
Table of Contents
