Table of Contents
Advertisement
3
Configuring the Switch
Web – Click Routing Protocol, DVMRP, General Settings. Enable or disable
DVMRP. Set the global parameters that control neighbor timeout, the exchange of
routing information, or the prune lifetime, and click Apply.
CLI – This sets the global parameters for DVMRP and displays the current settings.
Console(config)#router dvmrp
Console(config-router)#probe-interval 30
Console(config-router)#nbr-timeout 40
Console(config-router)#report-interval 90
Console(config-router)#flash-update-interval 10
Console(config-router)#prune-lifetime 5000
Console(config-router)#default-gateway 10.1.0.253
Console(config-router)#end
Console#show router dvmrp
Admin Status
Probe Interval
Nbr expire
Minimum Flash Update Interval
prune lifetime
route report
Default Gateway
Console#
Configuring DVMRP Interface Settings
To fully enable DVMRP, you need to enable multicast routing globally for the router
(page 3-261), enable DVMRP globally for the router (page 3-265), and also enable
DVMRP for each interface that will participate in multicast routing.
Command Attributes
DVMRP Interface Information
• Interface – VLAN interface on this router that has enabled DVMRP.
• Address – IP address of this VLAN interface.
• Metric – The metric for this interface used to calculate distance vectors.
• Status – Shows that DVMRP is enabled on this interface.
3-268
Figure 3-149 DVMRP General Settings
: enable
: 10
: 35
: 5
: 7200
: 60
:
4-301
4-302
4-303
4-303
4-304
4-304
4-305
4-307
Advertisement
Table of Contents
