Table of Contents
Advertisement
Drive guidelines
CAUTION: Do not remove an NVMe SSD from the drive bay while the Do Not Remove button LED is flashing. The Do
Not Remove button LED flashes to indicate the device is still in use. Removal of the NVMe SSD before the device has
completed and ceased signal/traffic flow can cause loss of data.
Depending on the configuration, this server supports SAS, SATA, and NVMe drives.
Observe the following general guidelines:
For drive numbering, see Drive bay numbering.
•
•
The NVMe SSD is a PCIe bus device. Do not remove a device attached to a PCIe bus without allowing it to first complete
and cease the signal/traffic flow.
•
The system automatically sets all device numbers.
•
If only one hard drive is used, install it in the bay with the lowest device number.
•
Drives must be the same capacity to provide the greatest storage space efficiency when drives are grouped into the same
drive array.
Rear panel components
Rear panel (standard)
Item
Description
1
Primary PCIe riser slots 1-7
2
Power supplies (4)
3
Serial port
4
iLO Management Port
5
Video port
120
Component identification
Table Continued
Advertisement
Table of Contents
