Microscan MS-9 User Manual page 223

Intercharacter Delay 3-18
Interface A-3
Interface Standards A-31
Interleaved 2 of 5 5-8
K
K Commands A-16
L
Ladder Calculation, single line A-27
Large Intercharacter Gap
Codabar 5-11
Code 39 5-5
laser beam i-xii
Laser Contorl
by ESP menu 10-2
Laser Control 7-15
Laser Framing 10-4, A-29
Laser High Warning 9-7
Laser Light, Specifications A-2
Laser Low Warning 9-8
Laser Off Time 10-5
Laser On Time 10-6
Laser On/Off 10-3
Latch Mode, discrete outputs 8-13
LED Indicators A-4
Lifetime Hours 9-12
Longitudinal Redundancy Check 3-17
Low Temperature Threshold 9-11
LRC 3-17
M
Macros 11-4
Mark, OMR 7-4
Master Database 12-11
Master Symbol Data
Enter 12-12
Master Symbol Data, Delete 12-15
Master Symbol Data, Request 12-14
Master Symbol Database Size 12-11
Master Symbol, store next symbol 12-13
Master Symbols, using 6-3
Match Counter 12-8
MS-9 Scanner User's Manual
Match Length, Matchcode 6-6
Match Start Position 6-5
Match, I/O Parameters 8-11
Matchcode
by ESP menu 6-2
by Serial Command 6-2
Matchcode Type 6-4
Matchcode, overview 6-3
Maximum Element 4-19
Mechanical A-2
Microscan Defaults A-21
Minimum Symbol Transitions 4-19
Mirror Type A-3
Mismatch
Symbol Data Output 8-3
Mismatch Counter 12-8
Mismatch Counter Reset 12-8
Mismatch or Noread, I/O Parameters 8-11
Mismatch, I/O Parameters 8-11
Model Selection 1-5
Motor Off 12-10
Motor On 12-10
Multidrop 3-6
Multidrop Addresses A-36
Multidrop Communications A-32
Multidrop, IB-131 A-12
Multisymbol 4-4
Multisymbol Decode Rate Test 12-5
Multisymbol Percent Test 12-5
Multisymbol Separator 4-4
N
Narrow Margins 5-19
Network Connector (25-pin), IB-131 A-10
New Master Pin 6-9
New Trigger 4-13
Noise Interference A-31
Noread Counter 12-8
Noread Counter Reset 12-8
Noread Message 8-6
Noread, I/O Parameters 8-11
Normally Closed 8-12
Normally Open 8-12
I-3