Serial Verification - Microscan MS-9 User Manual

Serial Verification

These commands are useful in removing any doubt about the scanner's
Usage:
acceptance and response to host configuration commands.
For example, if the current preamble is "SOM" and <Kd1, START> is
entered, the scanner will echo back <Kd1, SOM> since the attempted
entry "START" exceeds the four character limit for that command. There-
fore it is rejected and the existing "SOM" message is echoed back and
remains the preamble message.
Allows the user to verify configuration command status.
Definition:
Command Echo Status
ESP will not function whenever this command is enabled.
Important:
When enabled, a configuration command
Definition:
received from the host is echoed back to
the host with the resultant settings.
If a command with multiple fields is processed, some of the fields may
Function:
have been processed properly while others were not. The changes will
appear in the string echoed back so that the user will know which fields
did or did not change.
<K701,command echo
Serial Cmd:
put>
Default: Disabled
0 = Disabled
Options:
status,command beep status,control/hex out-
1 = Enabled
MS-9 Scanner User's Manual
Chapter 8 I/0 Parameters
Host
Scanner
8-9