Symbol Data Output; Symbol Data Output Mode - Microscan MS-9 User Manual

Symbol Data Output

Used when the host needs symbol data only under certain conditions.
Usage:
Defines the conditions under which decoded symbols are transmitted to
Definition:
the host.

Symbol Data Output Mode

<K705,symbol data output
Serial Cmd:
Default: Good Read
0 = Disabled
Options:
1 = Match
Disabled
Usage: Useful when an application only needs to use the discrete outputs and
can allow the scanner to do the decision-making. When set to Disabled,
the host does not need the symbol data and the communication lines are
used only for setup and status checks.
When set to Disabled, the scanner will not transmit any data that is gen-
Definition:
erated during a read cycle (symbols, noreads, etc.).
Match
Used in an application that requires specific symbol data information and
Usage:
needs to sort, route or verify based on match ing the specific symbol data.
When set to Match, the scanner transmits symbol data whenever a sym-
Definition:
bol data matches a master symbol. However, if Matchcode Type is set
to Disabled, it transmits on any good read.
Note: A noread can still be transmitted if Enabled.
Mismatch
Usage: Mismatch is typically used as a flag within the host system to prevent an
item from being routed in the wrong container.
With
Definition:
the symbol data information does NOT match the master symbol.
Note: A noread can still be transmitted if enabled.
2 = Mismatch
3 = Good Read
enabled, the scanner transmits symbol data whenever
Mismatch
Chapter 8 I/0 Parameters
mode,when to output>
MS-9 Scanner User's Manual
8-3