Appendix I Test Decode Rate - Microscan MS-9 User Manual

Appendices
Appendix I — Test Decode Rate
By Bar Code Configuration
You can enter the read rate test by scanning the following symbols:
To enable Bar Code Configuration, scan this symbol:
(This will also activate the read performance LED's on the scanner.)
To enable all symbologies, scan the following:
To start your read rate test, scan this symbol:
You should now be able to read any enabled symbol.
To end the read rate test and the bar code configuration program, scan this symbol:
This will terminate the bar code configuration mode. Changes made in configuration will
remain in effect, as would changes made in the menus or by serial commands.
MS-9 Scanner User's Manual
A-25