Pressure Switch; Belt (Agitate And Spin) - ALLIANCE AA9231 Service

Section 6 Adjustments
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.

49. PRESSURE SWITCH

Refer to Figure 45.
NOTE: DO NOT ADJUST PRESSURE SWITCH
IF WASHER IS WITHIN THE WARRANTY
PERIOD.
The pressure switch on pressure-fill automatic
washers is set at the factory for proper water fill
levels. However, if there is a problem of
overfilling or underfilling, the pressure switch can
be adjusted.
The maximum water fill level can be increased by
turning adjusting screw CLOCKWISE, and
decreased by turning screw
COUNTERCLOCKWISE.
One quarter turn of the adjusting screw represents
approximately one inch (2.54 cm) increase or
decrease of water level in washtub.
IMPORTANT: DO NOT turn adjusting screw more
than 3/4 of a turn in either direction as the switch
may be damaged and flooding could result.

50. BELT (Agitate and Spin)

No belt adjustment is required.
NOTE: After placing the motor and mounting
bracket in the washer, start the four hold-down
screws, but do not tighten them at this time. Pivot
the left side of the mounting bracket as far back as
it will go, then tighten the four screws. This
mounting bracket adjustment is necessary to ensure
the proper belt drive action.
60
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
Adjusting
Screw
Adjusting
Screw
Adjusting
Screw
Fixed Pressure Switch
Rotary Pressure Switch
Slide Pressure Switch
Figure 45
W003
32283