ALLIANCE AA9231 Service page 45

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
IMPORTANT: When removing the centering
springs, mark on the side of the outer tub what
notch the spring was hooked into. Springs must be
placed in the same notch when reinstalling. Do not
overstretch the springs. Mark the word "FRONT"
on the front side of the outer tub so the complete tub
module can be reinstalled in the same position.
o. Disconnect hoses between outer tub and pump
assembly.
p. Remove hose clamp holding pressure hose to
pressure switch accumulator. Then remove tape
holding pressure hose to outer tub.
q. Grasp outer tub and lift complete tub assembly
(with transmission, balance ring and pivot
dome attached) straight up and out of washer
cabinet.
r. Turn outer tub upside-down and set on
protective padding.
s. Remove screws and lockwashers holding each
support leg to outer tub. Refer to Figure 34.
Then lift transmission, balance ring and pivot
dome off tub.
32283 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
NOTE: To prevent porcelain damage, leg plates
must be installed on both sides of outer tub flange
when reinstalling support legs. (The thinner plate
must be installed between leg and tub flange and the
thicker plate must be installed on outside of tub
flange.) Do not overtighten the screws as this could
cause stripping or porcelain damage.
t. Turn outer tub upright and remove pressure
accumulator and grommet.
NOTE: When installing grommet into outer tub, the
thicker lip of grommet must be installed to outside
of tub. Lubricate outer surface of large opening of
accumulator with liquid soap to aid when
assembling the accumulator into the grommet.
Section 5 Service Procedures
W003
43