Agitator; Agitator, Drive Bell And Seal Kit Assembly - ALLIANCE AA9231 Service

To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.

25. AGITATOR

a. Open loading door.
b. To remove agitator by hand, place two agitator
hooks, No. 254P4P, under bottom edge of
agitator. Refer to Figure 12.
No. 254P4P
Agitator Hooks
Agitator
Figure 12
IMPORTANT: Hooks should be positioned 180
degrees of each other, and must be placed under
agitator fin for greater stability. If hooks are placed
between the fin area, damage to agitator may occur.
c. Using a rocking motion (back and forth)
carefully lift agitator off drive bell.
32283 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
26. AGITATOR, DRIVE BELL AND SEAL KIT
ASSEMBLY
IMPORTANT: If water is present in the washtub,
spin and pump out before attempting to remove the
drive bell and seal seat assembly.
a. Open loading door.
b. To remove agitator by hand, place two agitator
hooks, No. 254P4P, under bottom edge of
agitator. Refer to Figure 12.
IMPORTANT: Hooks should be positioned 180
degrees of each other, and must be placed under
agitator fin for greater stability. If hooks are placed
between the fin area, damage to agitator may occur.
c. Using a rocking motion (back and forth)
carefully lift agitator off drive bell.
d. Remove the screw and o-ring washer from the
top side of the drive bell.
NOTE: To remove the drive bell from the
transmission shaft will require using the No. 294P4
Drive Bell Tool.
Bolt
Indent
Jaw
Lip
Section 5 Service Procedures
Large
Nut
Wing
Nut
Jaw
Figure 13
W003
23