Symptom: Washer Will Not Agitate Properly - ALLIANCE AA9231 Service

Section 8 Service Procedures Unique to the Electronic Control Model Washers
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.

69. SYMPTOM: WASHER WILL NOT AGITATE PROPERLY

Washer will not
agitate properly?
Broken, loose or incorrect
wiring?
Correct wiring.
Inspect loading door
Replace control.
Replace control.
Replace control.
82
YES
NO
YES
NO
switch.
NO
NO
NO
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
By-pass pressure switch to allow agitation
without water in washtub.
With power cord unplugged, remove and insulate
wire from terminal "P6" on control.
With loading door closed, plug in power cord.
Choose cycle and press GO pad.
Loading Door Switch
120 Volts between terminal "N.O." (normally
open) on motor relay K3 and "P1" (neutral)?
Motor Relay K3
120 Volts between "COM" (common) terminal
on motor relay K3 and "P1" (neutral)?
Motor Relay K1
120 Volts between "P2" (START/AGITATE)
and "P1" (neutral) on control?
Motor Relay K2
Zero Volts between "P3" (START/SPIN) and
"P1" (neutral) on control?
Problem not related to electronic control.
YES
YES
YES
YES
W003
32283