ALLIANCE AA9231 Service page 38

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
d. Remove eight clips holding outer tub cover to
tub, lift cover off tub and set beside washer
cabinet. Refer to Figure 27.
Left Front
Clip Hole
Clip
Outer
Tub
Figure 27
NOTE: When installing outer tub cover, always use
a new cover gasket. Lubricate the gasket with liquid
soap to aid in assembly. Cover must be placed on
outer tub so notch on top edge of outer tub cover is
directly over left front clip hole in tub. Refer to
Figure 27. Starting with this hole, place each spring
clip in its respective hole and snap in place. Refer to
Figure 27 for proper clip installation.
36
1/8 Inch
Clearance
Notch
Clips
(8)
Outer
Tub
Cover
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
e. Remove four screws and washers holding
washtub to hub. Refer to Figure 28.
IMPORTANT: Porcelain Washtub Models – Use
care when tightening the screws to avoid chipping
porcelain on the washtub.
f. Lift washtub and lint filter out of outer tub.
IMPORTANT: When removing the washtub and
lint filter, DO NOT lift up on the lint filter as you
could damage the filter. Grasp the top flange of the
washtub and remove from outer tub.
NOTE: When installing washtub, always use a new
gasket between the tub and hub.
Washtub
Screws
Figure 28
W003
32283