Table Of Contents - ALLIANCE AA9231 Service

Section 1 - Safety Information
Locating an Authorized Servicer ............................4
Section 2 - Introduction
Customer Service ....................................................5
Nameplate Location ................................................5
Model Identification ................................................6
Section 3 - Troubleshooting
1. No Hot Water ...................................................7
2. No Cold Water .................................................7
3. No Warm Water ...............................................8
4. Water Fill Does Not Stop At Proper Level ......8
5. Timer Does Not Advance (Mechanical Timer
Models only) ....................................................8
6. No Agitation .....................................................9
7. Constant Agitation ...........................................9
8. Slow Spin or No Spin ....................................10
9. Constant Spin .................................................10
10. Drive Motor Overload Protector Cycles
Repeatedly ......................................................11
11. Outer Tub Does Not Empty ...........................11
12. Excessive Vibration .......................................11
13. Water Leaking From Outer Tub .....................12
Section 4 - Grounding
14. Wall Receptacle Polarity Check ....................13
15. Power Cord to Cabinet Top, Cabinet Top to
Control Hood Mounting Bracket, Pressure
Switch Mounting Bracket and Ground Tab on
Graphic Panel .................................................14
16. Main Wire Harness to Top Left Rear Corner
Gusset of Cabinet ...........................................15
17. Motor to Mounting Bracket to Base
(if present). .....................................................16
Section 5 - Service Procedures
18. Control Hood Assembly .................................17
19. Electronic Control ..........................................17
20. Timer ..............................................................21
21. Temperature Switch .......................................22
22. Pressure Switch ..............................................22
23. Graphic Panel .................................................22
24. Loading Door .................................................22
© Copyright 2004, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without
the expressed written consent of the publisher.
32283

Table of Contents

© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
25. Agitator ..........................................................23
26. Agitator, Drive Bell and Seal Kit Assembly ..23
27. Front Panel .....................................................25
28. Pump Belt .......................................................26
29. Drive Belt .......................................................26
30. Motor and Mounting Bracket .........................28
31. Idler Lever and Pulley ....................................29
32. Motor Drive Pulley or Pump Pulley ..............31
33. Motor Switch .................................................31
34. Pump Assembly .............................................31
35. Cabinet Top Assembly ...................................32
36. Door and Out-of-Balance Switch and Bracket
Assembly ........................................................34
37. Mixing Valve Assembly ................................35
38. Washtub and Lint Filter .................................35
39. Water Seal and Hub Assembly ......................37
40. Outer Tub .......................................................41
41. Drive Pulley and Helix ...................................44
42. Brake Assembly .............................................46
43. Lower Bearing Housing .................................47
44. Transmission Assembly .................................49
45. Balance Ring ..................................................54
46. Upper Bearing Assembly ...............................54
47. Snubber Pads ..................................................55
Section 6 - Adjustments
48. Leveling Legs .................................................59
49. Pressure Switch ..............................................60
50. Belt (Agitate and Spin) ..................................60
51. Belt (Pump) ....................................................61
52. Out-of-Balance Switch Trigger ......................62
Section 7 - Test Procedures
53. To Check Continuity Through Motor Harness
and Motor .......................................................63
54. To Check Continuity Through Base Harness,
Control Harness and Timer For Motor Start
Circuit ............................................................63
(continued)
1