Drive Pulley And Helix - ALLIANCE AA9231 Service

Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.

41. DRIVE PULLEY AND HELIX

a. Remove two screws from bottom edge of front
panel. Refer to Figure 16.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top.
Refer to Figure 16.
c. Loosen two front mounting screws and loosen
one rear mounting screw holding pump and
bracket to washer base. Refer to Figure 17.
Pivot entire pump assembly toward motor to
loosen belt tension.
d. Run belt off motor pulley, then remove belt
from pump assembly.
NOTE: After installing belt, adjust belt. Refer to
Paragraph 51.
Drive
Pulley
Lower Bearing
Housing
Leg
Plate
Balance
Ring
44
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
e. Reach in through front of motor mounting
bracket and move idler lever to left to release
tension on belt.
IMPORTANT: Use care when releasing idler lever
tension. If idler lever spring or helper spring is
overstretched, washer operation will be affected.
f. While holding idler lever, reach in and around
right side of motor and run belt off right side of
large drive pulley. Refer to Figure 18.
g. Remove belt from motor pulley and pull belt
out through front of motor mounting bracket.
IMPORTANT: When reinstalling belt, no drive belt
adjustment is necessary.
Figure 34
W003
Pivot
Dome
Brake
Assembly
Transmission
Assembly
Screw and
Lockwasher
32283